Return to the home page...

Go Back   Moyer Marine Atomic 4 Community - Home of the Afourians > Members List

blind navigator blind navigator is offline

Frequent Contributor

Visitor Messages

Showing Visitor Messages 1 to 1 of 1
  1. blind navigator
    05-07-2009 05:08 PM
    blind navigator
    Overheating issue-
    On 3 hour run, the temp gauge (usually shows 160F ) started climbing, eventually went to 240, engine ran normally, top of T-stat housing was cool to the touch, no steam out of the exhaust (lake water temp 50F), but engine smelled like it was running hot. Temp gauge/ sender were replaced a few years ago- anyone know the resistance value of the sender at the cold end, about 160, and the high end?
    I plan to pull the T-stat, but it looks original. I've been soaking the bolts with liquid wrench, but they don't budge. I don't want to snap off the studs-any thoughts on how much leverage/other steps I want to apply before I'm in the danger zone? If I can get it off, I'll soak it in white vinegar and check/replace it-maybe flush the whole motor. Motor is original 1974 A-4, fresh water, had the exhaust off last year to be rebuilt after finding water in the oil, ran fine after that; they didn't notice any huge amount of crud when the system was apart.

Statistics

Total Posts
Visitor Messages
Total Thanks
General Information
  • Last Activity: 04-12-2022 01:18 PM
  • Join Date: 05-29-2008

All times are GMT -4. The time now is 05:44 PM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2022, vBulletin Solutions, Inc.


Universal® is a registered trademark of Westerbeke Corporation

Copyright © 2004-2022 Moyer Marine Inc.

All Rights Reserved