Oil pressure adjustment screw leak

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • tommarchall
    replied
    Thanks so much all. I've received a replacement. In the meantime i tightened it up. It was at least a turn loose, so hopefully that takes care of it.

    Leave a comment:


  • Al Schober
    replied
    The washer that goes between the nut and the block is a special one that has a rubber center. This is to try and seal the leak path along the thread. If the washer doesn't have the rubber center or it's damaged, expect a leak.

    Leave a comment:


  • ndutton
    replied
    See your Moyer Marine Service and Overhaul Manual, page 5-2, figure 6 for additional information.

    Leave a comment:


  • Dave Neptune
    replied
    The nut just locks the adjusting screw so if you hold the screw in place only the nut will will come off. If you are going through the trouble of resealing I recommend that you get the new style conical adjuster to replace the ball that is probably still there. The ball can be a bit problematic getting out of the hole, sometimes a kick on the starter will push it out with a bit of oil so have a rag ready. The conical relief is slightly better and easier to work with. I think it a worth while upgrade if you are disassembling it anyway.
    It is easier to back out the screw to relieve the pressure when removing the assembly and your hand holding it while undoing will keep any popping from happening. The nut only locks the screw and only the screw is threaded into the block.

    Dave Neptune

    Leave a comment:


  • tommarchall
    started a topic Oil pressure adjustment screw leak

    Oil pressure adjustment screw leak

    I think I have a slow leak from the oil pressure adjustment screw. I’m going to try simply tightening it. But I’ve ordered the new gasket from Moyer.

    my question is: when I take off the nut will the spring pop? And if it does all come out, are their instructions on getting back in?

    thanks in advance!
Working...
X