#26
IP: 137.103.82.194
|
||||
|
||||
14 PSI would blow right past the cap on my HX. Is that cold?
Also watch for side effects from a hotter engine. You can run a glycol mix to at least 220 degrees, but that much heat may cause other issues. In my case steady running at 180 causes vapor lock issues after a couple of hours, which is why for now I am back to RWC. |
The Following User Says Thank You to joe_db For This Useful Post: | ||
TimBSmith (09-28-2022) |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Indigo Vs Martec | Flyingmike | Drive Train / Propellers | 21 | 03-28-2017 12:42 AM |
possible ignition issue? indigo E.I. | MN John | Ignition System | 4 | 08-13-2016 05:27 PM |
Indigo or Martec | Tar34 | Drive Train / Propellers | 13 | 12-18-2013 12:13 AM |
Just installed a new Indigo Thermostat kit and now old water pump does not pump | sailmakered | Cooling System | 16 | 10-03-2011 04:17 PM |
Installed the Indigo PCV kit today | Baltimore Sailor | General Maintenance | 6 | 04-09-2009 01:22 PM |