Hinged reversing assembly plate!

[Guest]

I am so sick and tired of taking my reversing assembly lid off (cramped conditions, the usual) that I would love a hinged lid that would just pop open and latch down opposite the hinge. We could then tighten up four short (3/8" long) bolts into the holes when all adjustements were done for good measure. At present, you can't work on your reversing assembly without bolting the lid down. And unbolting it. And bolting it down. And lets not forget getting all the grounding terminals connected each time.

[ArtJ]

Removable plug in reversing cover for oil changes

I would like to see the reversing cover available with a threaded 3/4 inch
tapped and removable plug for ease of oil change without removing the cover and causing \
possible gasket leaks.

[rigspelt]

And lets not forget getting all the grounding terminals connected each time.

I got all the ground connections off the engine except one main ground cable, and ran other grounds to a ground buss bar. Solved a lot of problems.

[67c&ccorv]

I got all the ground connections off the engine except one main ground cable, and ran other grounds to a ground buss bar. Solved a lot of problems.

Same here.