#22
IP: 64.228.143.126
|
|||
|
|||
Flamethrower coil from Moyer
Hi all,
Just to throw a monkey wrench in the proceedings, I have a Flamethrower coil that I got from Moyer, that when measured shows only 2.9 ohms across the - and + terminals. In fact the case of the coil says 3.0 ohms, yet it was originally order from Moyer as the internally resistered coil. It has not been installed as yet, and I was wondering if I should be adding a external resistor to is as well? |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Some Comments About Coils | Don Moyer | Ignition System | 42 | 10-17-2017 05:03 PM |
Hot Coil and High Alternator Output | Triton106 | Electrical | 53 | 10-02-2011 07:12 PM |
engine stops | Possum | Troubleshooting | 4 | 04-20-2011 09:19 AM |
Information about information and oil pressure issues | Don Moyer | Announcements | 0 | 04-14-2009 08:30 AM |
Hi, new member with a problem | cpdeeley | Introductions | 10 | 01-11-2009 01:43 PM |