#1
IP: 72.215.169.82
|
|||
|
|||
Hinged reversing assembly plate!
I am so sick and tired of taking my reversing assembly lid off (cramped conditions, the usual) that I would love a hinged lid that would just pop open and latch down opposite the hinge. We could then tighten up four short (3/8" long) bolts into the holes when all adjustements were done for good measure. At present, you can't work on your reversing assembly without bolting the lid down. And unbolting it. And bolting it down. And lets not forget getting all the grounding terminals connected each time.
|
#2
IP: 71.232.145.132
|
|||
|
|||
Removable plug in reversing cover for oil changes
I would like to see the reversing cover available with a threaded 3/4 inch
tapped and removable plug for ease of oil change without removing the cover and causing \ possible gasket leaks. |
#3
IP: 142.68.253.180
|
||||
|
||||
I got all the ground connections off the engine except one main ground cable, and ran other grounds to a ground buss bar. Solved a lot of problems.
__________________
1974 C&C 27 |
#4
IP: 64.231.125.40
|
||||
|
||||
Same here.
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Reversing assembly on Elm Street | duncan59 | Reversing Gear | 3 | 07-07-2008 05:49 PM |
Breaker Plate - PerTronix | swokrams | Ignition System | 2 | 12-17-2007 07:42 AM |
reversing gear assembly | gilbert landin | Overhaul | 2 | 12-06-2005 11:02 PM |
Water Jacket Side Plate Leak | 1973 Ericson | Cooling System | 5 | 11-09-2005 10:43 PM |