|
#1
IP: 173.19.162.137
04-22-2014, 08:19 AM
|
||||
|
||||
Starting Issue Electrical
Default Electrical Starting Issue
1994 Mercury mariner 115 Hp. Replaced Stator, trigger, solenoid, (starter less than year old) battery cables, battery, fuel/water separator, primer bulb with fuel line and cleaned connections. Started right up and stayed running for good 15 minutes. Tried a hour later turned key nothing just a click from solenoid and no trim either. Multi meter tested and a full 12v going to bottom terminal on solenoid no reading on top terminal or side terminals on solenoid. Is it possible a new solenoid can blow? Bad ground wire? I by new OEM parts from a marine parts store. 
|
 |
| Tags |
| electrical, ignition, soleniod, starter, wiring |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Engine Starting Issue | Gabe | Fuel System | 16 | 07-26-2013 09:52 PM |
| Hand starting | ndutton | General Interest | 25 | 12-04-2012 11:50 AM |
| Starting (and staying started) issue | gpd955 | Fuel System | 0 | 07-31-2007 03:15 PM |
| Engine Rattling/Loss of RPM issue | jkenan | Troubleshooting | 5 | 11-25-2005 04:01 PM |
| Engine Starting Issue | jkenan | Troubleshooting | 0 | 08-19-2005 11:17 AM |
Linear Mode
