#1
IP: 69.245.172.243
|
|||
|
|||
Dimensions & Weight?
New here... I've tried (and failed) to bring this info up thru searches of the FAQ & Gen Forums. Point me to where this info is archived & I will be grateful.
I need to understand the LxWxH & weight of the A-4 to see if it would work in a smaller powerboat. Pics with a ruler laying on the motor would be a great help. TIA! Richard Johnson Peru, Indiana on the banks of the Wabash... |
#2
IP: 206.125.176.3
|
||||
|
||||
HI Richard, Welcome to the forum. This information is archived in several places on the web..one place is the C&C owner's site. - http://cncphotoalbum.com/atomic4/atomic4specs.htm
I think this is the basic info you are looking for: Maximum operating angle 15° Length overall UJ: 26 ¾ in, UJR: 31 15/16 in, UJVD: 35 13/16 in Height above crankshaft centreline 13.125 in Maximum width 18.250 in Offset – crankshaft to propeller shaft UJ: 0 in; UJR: 1.042 in; UJVD: na Base depth below centreline 6 in Weight UJ: 310 lb; UJR: 330 lb; UJVD: 335 lb Models 5101 / UJ - base configuration Atomic Four 5111 / UJS - Stevedore configuration for Canadian market, power limited to 15 hp with intake manifold restriction) 5102 / UJR - reduction gearbox mounted on transmission, 2.04 ratio standard 5112 / UJSR - Stevedore configuration with reduction gearbox mounted on transmission, 2.04 ratio standard 5103 / UJVD - 20° angle Walter V drive gearbox mounted on transmission, 4 gear ratio options including 1:1 5113 / UJSVD - Stevedore configuration with 20° angle Walter V drive gearbox mounted on transmission, 4 gear ratio options including 1:1
__________________
-Shawn "Holiday" - '89 Alura 35 #109 "Twice Around" - '77 C-30, #511 with original A-4 & MMI manifold - SOLD! (no longer a two boat owner!!) |
#3
IP: 69.232.227.128
|
|||
|
|||
Hi Richard,
I have scanned and attached the page from the Atomic 4's spec sheet that provides the dimensions. Hope that helps. |
#4
IP: 71.65.36.129
|
|||
|
|||
Dims & Wt Found!!!
Perfect....This engine must be solid...I do not think a Chevy small block weighs 300 lb
OK, now for the weight & balance calcs....I'm going to be busy for awhile.... rwj |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Bed dimensions | bcooke | General Interest | 4 | 11-18-2009 06:53 AM |
Short block weight | lat 64 | Overhaul | 10 | 10-24-2008 01:56 PM |
side plate bolt dimensions | m_galligan | Cooling System | 0 | 07-30-2007 01:03 AM |
Thermostat dimensions | Walter Pearson | Cooling System | 3 | 06-06-2005 07:38 AM |