#1
IP: 75.3.205.97
|
|||
|
|||
Erickson 35 rudder head
I know this is a little naughty, but the boat does have an A4 in it!
I know there are loads of people out there with 1970s sailboats perhaps with the same problem. I need to replace the Chromed/bronze rudder head that connects the tiller bar to the rudder on this 1976 Erickson 35. The original may be Edson but there is no markings on it, and current Edson catalogs do not show anything that will fit the 3 inch rudder stock. Any information to track one down will be apprieciated Thanks Anyone |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Defective Head/Manifold Studs | Don Moyer | General Interest | 2 | 09-29-2021 07:43 PM |
Erickson 35 rudder head | anglosax | General Interest | 2 | 04-15-2007 01:58 PM |
additional persuasion to remove studs | skhorleb | Overhaul | 3 | 03-12-2007 04:40 PM |
Head Holes | Jim Mac | Overhaul | 2 | 02-27-2007 06:54 PM |
Removal of the cylinder head studs | Unregistered | General Maintenance | 1 | 12-18-2005 12:34 PM |