#1
IP: 96.244.241.192
|
|||
|
|||
exhaust manifold
I may have a possible clearance issue getting the exhaust manifold clear from mounting stud. there is a 2 inch space from the tip of the mounting stud to the side wall of the engine compartment. the exhaust manifold is around 2.5 inches wide. It looks like I may not have clearance to get off the manifold from the engine.
if this is the case, other than shifting the engine, Which I don't want to do, any suggestions? this is on catilina 27. Not a lot of rom in the engine compartment. Last edited by sparky621; 12-24-2008 at 09:04 PM. Reason: clarification |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Seepage from exhaust manifold bolt | charles@pricefarrington.c | General Maintenance | 0 | 09-19-2008 01:25 PM |
Exhaust Flange and Manifold Gasket Replacement | Kurt | Exhaust System | 2 | 07-14-2008 05:28 PM |
Re-installing exhaust manifold | 1973 Ericson | Exhaust System | 2 | 11-29-2005 09:31 AM |
manifold water leak v/s exhaust waterjacket leak, or BOTH | alkaid | Exhaust System | 1 | 08-23-2005 02:36 PM |