#1
IP: 199.66.171.157
|
|||
|
|||
Looking for a prop shaft coupling puller
Hello all!
My Cal 2-27 needs a new shaft log hose. The only way to replace it is to remove the prop shaft from the coupling. Does anyone know what kind of coupling puller I'll need for this and where I could buy it? Will I be able to re-use the original coupling if there is no corrosion? The boat has only been sailed in freshwater for the last 20 years and has been in dry storage for half that time, so I am guessing corrosion won't be much of an issue. Any tips for this project would be greatly appreciated. Thanks guys and gals! Laura |
#2
IP: 32.211.28.40
|
||||
|
||||
There are commercial pullers available, but most (at least the ones I've used) need too much room to be of use.
I recommend you buy/borrow a few long 3/8" fine thread bolts - the longer the better - along with a few matching nuts. Thread the nuts all the way onto the long bolts. Unbolt the existing coupling from the transmission and move it back far enough to put a socket (or similar spacer) between the end of the shaft and the transmission. The spacer diameter has to be smaller than your shaft. Move the shaft back towards the transmission, keeping the spacer centered. Now install the long bolts through the coupling and into the transmission flange. Tighten the nuts against the coupling until things are just snug. If you haven't done so yet, remove any set screws between the coupling and the shaft. Now, gently tightening the nuts against the coupling should break the coupling loose from the shaft. You don't want to break the transmission flange! A bit of heat from a propane torch may help. I've found that the coupling gets tight to the shaft because of corrosion on the inside of the coupling (cast iron). Once the coupling is off, you can clean up the bore with sandpaper and it will easily slide back on. |
#3
IP: 72.69.36.126
|
|||
|
|||
http://www.moyermarineforum.com/foru...ead.php?t=4540
My advice: cut the coupling off now with a Sawzall and replace it with Moyer's split coupling of the appropriate shaft diameter. Yes, the $175 split coupling, which will be easy to remove in the future. The removal and replacement will take 20 minutes. https://moyermarine.com/product-cate...etrain/page/2/ You won't take this advice, but please come back after you finish this project and let me know if you think this is sound |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Prop shaft coupling | KevBYC | Drive Train / Propellers | 4 | 02-16-2016 07:04 PM |
It started as a simple Cutless bearing replacement... | cdhickey | Drive Train / Propellers | 8 | 05-02-2015 12:48 PM |
Replacing the Prop Shaft onto the Coupling | Bryanphaas | Drive Train / Propellers | 11 | 04-22-2014 02:00 PM |
Stripped Threads in Prop Shaft Coupling | jkenan | Overhaul | 1 | 01-12-2006 01:50 PM |
Oil in the bilge. | Sailwood | Troubleshooting | 1 | 07-19-2005 02:15 PM |