#1
IP: 75.157.247.99
|
|||
|
|||
aft housing removal + install
Thinking of removing the aft housing to clean and paint better. Really difficult to get in behind the oil pump and pulley. Anything special I need to know about that removal? Hard to do?
Thanks, Marty
__________________
Marty 1967 Tartan 27 Bowen Island, BC |
#2
IP: 216.115.121.240
|
||||
|
||||
Hardto Duit insitu
If you are not taking off anything else and it' still in the boat, then yes, it will be difficult.
It is easier to put back on when you are fixing the whole engine and it is on the bench. It is tricky to keep the gasket from folding up while sliding the case in with the pan still on the engine. Also it takes a few tries to get the pilot shaft in the bearing and that grinds up the gasket! I personally would not do it unless the gasket is really leaking bad. I would just touch up the paint without messing with all the problems of removal. russ
__________________
Whiskeyjack a '68 Columbia 36 rebuilt A-4 with 2:1 "Since when is napping doing nothing?" Last edited by lat 64; 10-23-2011 at 02:44 PM. |
#3
IP: 75.157.247.99
|
|||
|
|||
too hard
Thanks, Russ - that sounds right to me.
-Marty
__________________
Marty 1967 Tartan 27 Bowen Island, BC |
#4
IP: 216.115.121.240
|
||||
|
||||
I haven't done this since I rebuilt mine in '09, so I cant remember it all for sure. But , I think the MMI manual has a good step-by-step of how it should be done in a complete overhaul.
good luck, Russ
__________________
Whiskeyjack a '68 Columbia 36 rebuilt A-4 with 2:1 "Since when is napping doing nothing?" |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Thermostat Housing Removal | Erik | Cooling System | 1 | 10-10-2011 07:19 PM |
Thermostat installation instructions ( with spacer kit and original housing ) | seapadrik | Cooling System | 11 | 07-06-2011 02:35 PM |
Pearson 35 Upgrading to 2 to 1 reduction | jeffgerritsen | Pearson | 41 | 02-24-2011 02:29 PM |
New Products From Moyer Marine | Don Moyer | Cooling System | 0 | 10-05-2005 02:03 PM |