#1
IP: 74.88.0.97
|
|||
|
|||
Copper tube
I'm about ready to set my engine back on the beds but have a question.
I cannot for the life of me remember where the copper tube - just in front of the carb and behind the flywheel goes. I've circled it in the Moyer photo attached and it appears capped off. What is this for? Can I cap it? I have an MMI manifold if that matters I do recall on my previous engine I teed in the fuel pump switch here, but this motor has it installed at the rear. Second picture is a short view of what i am installing...I got bored so color... Thanks All |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
copper tube to Oil Gauge | Marty Levenson | Overhaul | 6 | 08-22-2016 01:18 PM |
Copper tube from Carburetor to Manifold | Crazer | Wanted to Buy - Other items | 4 | 12-14-2013 06:32 PM |
CROSSOVER TUBE and WATER PRESSURE SENDING UNIT | Jim Bates | Cooling System | 7 | 05-20-2013 11:24 AM |
Carburator Success story - Bad Scavenger Tube | uminski | Fuel System | 4 | 10-10-2012 12:20 AM |
Oil fill tube | Rob Salinas | Introductions | 2 | 08-02-2012 10:45 PM |