#1
IP: 98.144.228.132
|
|||
|
|||
boat issues for spring
Hi again
I have an old columbia 31 and am in need of new(used hopefully) side mount controls. Here is a link to what I believe I'm looking for: http://www.seastarsolutions.com/wp-c...mjb-series.pdf question is ...can someone recommend somewhere I might find this used ? $600.00 seems a bit stiff for a new one. Also, ...last year I had real issues with the idle. The motor (atomic4) ran great at speed but stalls at high idle. Any ideas ?? thanks in advance for any advice |
#2
IP: 24.152.132.140
|
||||
|
||||
It might need a little TLC but check this out:
https://www.ebay.com/itm/Boaters-Res...kAAOSwOHpcRi9m
__________________
Neil 1977 Catalina 30 San Pedro, California prior boats 1987 Westsail 32, 1970 Catalina 22 Had my hands in a few others |
#3
IP: 72.45.12.14
|
|||
|
|||
Not sure where you are located, but try Josh at Anchors and Oars in Grasonville, MD (Kent Narrows). He parts out old boats and has all manner of stuff.
|
#4
IP: 32.211.28.40
|
||||
|
||||
You may also run across a similar Marmac control unit like was installed on the early Tartan 30s. Construction similar to the Teleflex unit, using those split plastic bearings. Should have similar corrosion/binding issues, which respond well to disassembly & cleanup. Main difference is that the Marmac had removable control levers.
|
#5
IP: 98.144.228.132
|
|||
|
|||
Thanks all....I'll give them a shot!!
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Alberg 35 hove to under bare poles? | liveaboardL | Alberg | 24 | 06-26-2014 01:16 PM |
Removing the engine from your boat | Don Moyer | General Interest | 13 | 06-27-2008 11:06 AM |