#1
IP: 71.101.217.55
|
|||
|
|||
water pump = water in oil
I had water in my oil , and after many hours of testing , realized that when I replaced the crank and bearings , I had also rebuilt the water pump and installed the seal on the water chamber side backwards . Water was squirting across the weep hole and striking the oil seal . From there it ran down onto the shaft and thru the oil seal and into the oil pan . so , make sure the seals go in facing the correct way !
|
Tags |
None |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Leaking Water Pump Seals | Unregistered | Cooling System | 4 | 11-02-2008 12:52 PM |
Emergency Bilge Pump (T in water intake) | sailorken | General Interest | 0 | 11-05-2005 08:40 AM |
water pump priming | meander | Cooling System | 1 | 06-06-2005 02:48 PM |
Replacing water pump | Bryan Howell | Cooling System | 7 | 11-27-2004 11:46 AM |
Water pump impeller questions | Mr. K | Cooling System | 1 | 11-16-2004 09:36 AM |