#1
IP: 45.48.80.165
|
||||
|
||||
V Drive & reversing gear - Advice needed.
Hello, more advice is needed. I have a boat with a blown motor in it, looks like it used a V drive, the replacement motor I bought seems to be direct drive.
Im reading through the overhaul section on the reversing gear removal. Just curious. Would I pull off the old transmission from my motor on my boat then install it on the replacement motor. The old motor is the reddish pink, the replacement is blue. See pics. Thanks. I'm just not sure if I could go straight drive or go through the hassle of hooking up the V drive. I'm not a mechanic, although I do have the manual, is this job worthy of hiring out? Edit: I keep running into issues, from my other posts, I discovered a lot of rust in the head under the thermostat. I bought the motor for $1000, now I'm thinking I am just going to keep spinning my wheels. All this time and energy could be justified potentially by buying a newly rebuilt engine, and I could just say F* it, and forget about all this crap. Last edited by Rando1201; 05-10-2020 at 05:59 PM. |
#2
IP: 32.211.28.40
|
||||
|
||||
The BIG question here (in my mind) is whether the blue engine is better than the pink one. I'm not going to try to answer that question here.
Yes, the transmission outputs are different. Pink engine has a spline output for the V-drive. Blue one has a keyed output for direct drive. Unless you're going to rebuild the interior of your boat, you're going to stay with the V-drive. Easiest way to get the blue engine to have a spline output is to transplant the transmission internals from the pink engine to the blue engine. Not a bad job. Caveat is to ONLY transplant the internals. Don't try to swap transmission casings too, as the the dowel pins won't line up. Any questions (other than blue vs pink) get back to me. |
The Following User Says Thank You to Al Schober For This Useful Post: | ||
Ando (05-10-2020) |
#3
IP: 45.48.80.165
|
||||
|
||||
Quote:
|
The Following User Says Thank You to Rando1201 For This Useful Post: | ||
Ando (05-10-2020) |
#4
IP: 108.185.228.107
|
||||
|
||||
Quote:
Keep at it and thank you for the very interesting question about transferring a v-drive from one engine to another. Very interesting. I’m still learning |
The Following 2 Users Say Thank You to Ando For This Useful Post: | ||
Administrator (05-11-2020), Rando1201 (05-11-2020) |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Resetting Forward Drive Gear | Trés 30 | Reversing Gear | 4 | 07-31-2014 04:59 PM |
still have reversing gear problems. | weremeer | Reversing Gear | 6 | 06-25-2011 12:09 PM |
Replacing gaskets on reversing gear and reduction gear housings | phorvati | Troubleshooting | 1 | 10-06-2008 02:10 PM |
Reversing Gear Slippage Issues? | SEMIJim | Reversing Gear | 9 | 07-16-2008 08:48 PM |