#1
IP: 134.134.139.73
|
||||
|
||||
A puzzle, finishing someone else's rebuild
All--
I bought a old A4 build-in-process from a guy that ended up going diesel. So it basically came as a partially assembled short block and a bin of parts. Basically, I got an A4-in-box and now trying to figure out what been done and what needs redoing. As a bit of foreshadowing, the bores were not cross-hone, the numbered pistons are all in the right holes, but the arrows are all pointing towards the flywheel. (sigh) And half of numbers on the connecting rod/caps are on the side with the cam. The block has been stripped of paint, but water jacket cover looked like it had never been removed... and that was true. I broke 4 of the bolts removing the cover and it was full of scale. So I just pulled the piston/rod assemblies and found a bit of good news. The crank was ground and rod bearings are new. Also, the piston rings are new as well. Since I don't have any docs on the what he bought and some of the assembly has been incorrect, how do I determine if the rings are installed correctly?
__________________
Thanks, Ron Portland, OR Last edited by ronstory; 07-06-2019 at 01:48 PM. Reason: typo |
The Following User Says Thank You to ronstory For This Useful Post: | ||
adab1402 (12-02-2020) |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Atomic 4 rebuild. | Captain Crunch | General Interest | 14 | 07-05-2019 08:12 PM |
A4 Rebuild | Van_Isle | Overhaul | 10 | 07-09-2015 03:00 PM |
To Rebuild or Not To Rebuild (That is the Question) | jkenan | General Interest | 13 | 02-07-2011 03:29 PM |
Proud Rebuild | mike7a10 | General Interest | 4 | 04-21-2010 05:38 PM |
Rebuild, Engine Rebuilder, Or PA ???? | JasperWindvane | Overhaul | 1 | 01-22-2006 09:22 AM |