#1
IP: 156.57.175.211
|
|||
|
|||
adjust idle
Hello All,
I have a small issue in that I cannot seem to set the carb idle to 600ish RPM. The engine starts on 2-3 revolutions but when I throttle up it will not return to a low idle, I would guess it comes down to only 11-1200 RPM. I use the choke to start but don't think it is truly needed. I have the MMI hand book but I don't see where the adjustment is, perhaps I am not reading thoroughly enough. If I reach in to the throttle arm on the carb I can drop the idle to where it sounds correct. Any help would be appreciated, thanks, Joe |
#2
IP: 72.194.219.196
|
|||
|
|||
Sounds like a linkage problem.
Lots of times the outer cover is not firmly fixed down and it moves, not the control cable, when the control lever is moved. TRUE GRIT |
The Following 2 Users Say Thank You to JOHN COOKSON For This Useful Post: | ||
Dave Neptune (08-21-2018), sastanley (08-21-2018) |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Good Problem | Jimmy | General Interest | 6 | 05-14-2012 10:04 PM |
Erratic Engine Speed | Unregistered | Troubleshooting | 3 | 01-24-2012 10:12 PM |
Issues at idle | TomG | Fuel System | 39 | 10-19-2011 06:31 PM |
Suspected Idle Circuit Blockage - causing idle problems | dman535 | Fuel System | 15 | 07-19-2009 07:49 AM |
Idle RPM | tartan30cirrus | General Maintenance | 6 | 05-17-2005 06:58 PM |