Atomic 4 Parts

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts
  • marthur
    Afourian MVP
    • Dec 2004
    • 831

    Atomic 4 Parts

    Atomic 4 Parts--$450 takes the whole lot.

    Going Diesel! Because I am buying a diesel equipped boat, I am selling my entire Atomic 4 parts collection. I ended up with many good condition parts because I bought a project motor and a whole boat load of parts from a fellow moving across the country (and also buying a diesel boat). The project motor ended up with a damaged block which had to be scrapped. And I ended up with all these great parts I can no longer use in addition to the usualy suspects that I purchased along the way. The majority of these parts were to be my drop in spares or to be installed on the completed project motor. I did not keep the junk.

    Here is the list (You get anything else that turns up when we load up your loot):

    Complete set of gaskets.
    DUAL ACTION Thermostat (new)
    Exhaust flange (NEW)
    Starter (new)
    Carburetors (2)--one good to go, one may need rebuild
    Carb Rebuild kit, misc jets, CARB SEALS (not available in the Moyer rebuild kit) and gasket.
    Oberdorfer / MMI Impellers (one new, one usable removed at 150 hours).
    Distributor (Delco)
    Fuel pumps and misc parts.
    Thermostat housing (early model)
    Cylinder heads (2 early, 1 late--Late model head is milled flat and ready to install. All in good condition).
    Exhaust Manifold
    Water jacket side plate (2)--early model. One good, one usuable.
    Early model valve covers (2)--these are a super nice feature of the early model motor.
    Coils (2)–condition unknown
    Alternator
    Oberdorfer water pump, Sherwood water pump. Pumps may need new seals.
    Prop coupling
    Starter solenoids (one early and one late model)
    Oil pumpout hand pump. May need seal.
    4 pistons with NEW UNUSED Rings, 3 oversize pistons.
    Oil pumps (2) with at least one good screen.
    Accessory drives (2)
    Complete reversing gear
    Oil Pan, transmission cover
    Early model cross over tube (2?)
    Two useable crankshafts
    One useable camshaft

    A large variety of original bolts, studs, nuts, gears and internal parts, etc... from a complete teardown and a half.

    $450 Located in Grand Rapids Michigan.
    I can drive a couple of hours to meet you.

    EMAIL ME: then I will get your message on my phone
    zephyr4 at comcast dot net
    Last edited by marthur; 12-20-2016, 10:42 AM.
    Mike
  • marthur
    Afourian MVP
    • Dec 2004
    • 831

    #2
    Parts are sold except for a late model flywheel (new), oil pan and reversing gear cover. If you need one, make an offer!
    Mike

    Comment

    • marthur
      Afourian MVP
      • Dec 2004
      • 831

      #3
      Parts are all gone
      Mike

      Comment

      Working...
      X