#1
IP: 216.183.133.13
|
|||
|
|||
Shaft seal on a Sherwood Water Pump
The A4 on our venerable C&C Corvette has a Sherwood water pump, which I am rebuilding. I need confirmation that A, the Sherwood has only 1 shaft seal, and B, the steel side faces out agaist the motor. It would appear to me that the steel side should be pressed until flush with the mounting plate. Although a press fit, should any sealant be used to make the outside edge of the seal impervious to water seepage? Can I coat the impellor with grease prior to installation?
Thanks Erwin Thornbury, ON |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Water Pump Shaft Leak | Erik | Cooling System | 16 | 08-14-2011 02:14 PM |
Raw Water pump failure in FWC system | Tom Witzel | Cooling System | 0 | 07-25-2006 11:21 AM |
water pump = water in oil | Unregistered | Cooling System | 0 | 04-14-2006 10:17 AM |
How to remove water pump shaft? | Unregistered | Cooling System | 1 | 11-01-2005 09:18 AM |
Water Pump Shaft | mingamells | Cooling System | 1 | 10-04-2005 07:13 AM |