#1
IP: 172.58.35.156
|
|||
|
|||
Quick question...
I fiiiiiinally got the coupling nut off the (front?) of the engine and got the block split open. I'm trying to remove the crankshaft as the cylinders are stuck and my plan is to bang them out with a 2x4. I ran into the issue that I can't seem to get the nuts that keep the cylinder to the crank off. Can't get a wrench on there because it will only bite the last quarter or so and a socket won't fit because there's no clearance. Anyone have a trick for getting these off? They are torqued down pretty good.
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Quick RPM Question | sdemore | Troubleshooting | 24 | 09-02-2018 06:19 AM |
Quick question on running without a thermostat | Bratina | Cooling System | 10 | 05-02-2018 10:36 PM |
Quick water pump question | robshepherd | Cooling System | 10 | 09-27-2013 06:45 PM |
Quick question | team118 | Troubleshooting | 4 | 08-05-2012 04:31 PM |
Quick ignition wiring question | ILikeRust | Ignition System | 2 | 05-28-2011 05:57 PM |