#1
IP: 23.135.32.138
|
|||
|
|||
Rust on inside of cylinders
I received this engine with some water in the cylinders. It sat that way for about 1-2 weeks before I was able to open it up and clean it out. It is currently seized and this is what the inside of the cylinders look like. Pictures are in reply.
What do you guys recommend for taking care of the rust? I've been spraying it with PB blaster continually, and been wiping it gently with blue paper towels, but it doesn't seem to clean it off. Does it only require honing? Full reboring? Total scrap?? Cheers! Last edited by ajgaines; 08-28-2019 at 12:48 PM. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Lower cylinder wall rust through and sticking tappets! | bondobob | Overhaul | 4 | 11-16-2010 04:42 PM |
Water in cylinders and no compression | gregt | Troubleshooting | 4 | 07-26-2010 12:21 PM |
Siezed engine - water in cylinders and pan | MikeDSmith | General Interest | 4 | 09-28-2007 08:17 AM |
water in the cylinders - engine won't start | dtelep | Troubleshooting | 5 | 06-06-2007 10:18 AM |
Diagnosing water in cylinders | raleighm | Troubleshooting | 1 | 05-30-2007 12:50 PM |