Return to the home page...

Go Back   Moyer Marine Atomic 4 Community - Home of the Afourians > Discussion Topics > Troubleshooting

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #1   IP: 68.114.124.144
Old 04-06-2019, 05:39 PM
SPNetricks's Avatar
SPNetricks SPNetricks is offline
Senior Member
 
Join Date: Mar 2019
Location: Slidell, La
Posts: 16
Thanks: 0
Thanked 1 Time in 1 Post
A little help

Went to the boat today and did some engine work. Took a few pics to get some feedback on. The distributor has a cap with two screws (no clips), does that mean something? The distributor looks like EE, right? The rotor is a little pitted, but the inside of the cap looks good. Fairly new 8mm wires. Coil looks good, and has 4.1 ohms across it.
I'm working on giving it a tune up and a rewire. The engine was running but hard to start. I plan on checking the timing after the rewire and tune up. I tried to take the plate under the rotor off, but it was lifting the center rod up too. So I left it in place till I could get more info of what is going on.
I am open to any comments, questions, or advice about what you see in the pics or what I've said. Also the tube above the flame arrester is missing. ?
Attached Images
     
Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 04:56 AM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.


Universal® is a registered trademark of Westerbeke Corporation

Copyright © 2004-2024 Moyer Marine Inc.

All Rights Reserved