#1
IP: 50.101.68.230
|
|||
|
|||
Gas in oil drip from drive shaft engine connection area?
5 years of no use and have a leak. Did compression test on all cylinders. 2 fire well and have 110+ ....2 not firing 95 + compression. Replacing distributor cap, wires, plugs oil change and will try starting this week. Also had gas as chalky mixture in exhaust outflow. Gas due to non firing cylinders I assume.
Any suggestions? |
#2
IP: 98.209.31.214
|
||||
|
||||
Is this gas on the exterior of the engine? If it is, you need to trace the fuel path looking at connections carefully until you find the leak.
One place in particular is the bowl of a mechanical fuel pump (if you have one).
__________________
Mike |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Shaft back in, how worried should I be about alignment | JimF | Drive Train / Propellers | 9 | 06-23-2016 09:24 PM |
Prop Shaft - where to start and end.... | bradh | Drive Train / Propellers | 26 | 03-27-2016 10:42 PM |
Removing the engine from your boat | Don Moyer | General Interest | 13 | 06-27-2008 11:06 AM |
Overheating problems | jdaly986 | Cooling System | 1 | 01-16-2008 10:32 AM |