Return to the home page...

Go Back   Moyer Marine Atomic 4 Community - Home of the Afourians > Discussion Topics > General Interest

Reply
 
Thread Tools Display Modes
  #1   IP: 174.216.24.117
Old 05-15-2018, 07:45 PM
wristwister's Avatar
wristwister wristwister is online now
Senior Member
 
Join Date: Nov 2013
Location: Arlington, WA
Posts: 121
Thanks: 0
Thanked 33 Times in 18 Posts
Did you know these old A4s run fine on 2 cylinders?

Well ... not quite "fine", a little rough, but still ...

I just finished the rebuild of my A4, and I've been running it up to temp a few times for the break in oil. Sounded slightly rough to me, but hard to tell unmuffled and with no load, so I assumed it was running fine. Then last night, just for kicks, I pulled one plug wire at a time. Pulled #1 wire, no change! I thought "that's odd! You'd think it would run rougher on 3 cylinders. Plugged # 1 back in and repeated with plugs 2, 3 & 4. Each of those resulted in pronounced running roughness. Went back to #1, no change again!

After bit of troubleshooting I found out the #1 plug was bad. Replaced it and now it's running quite smoothly.

Anyway, I just found it interesting that these old beasts run rough but fine on 2 cylinders. Good to know if I'm ever out "there" and lose a cylinder or 2 for any reason.
__________________
"A ship in the harbor is safe ... but that's not what ships are built for.
Reply With Quote
The Following 2 Users Say Thank You to wristwister For This Useful Post:
CajunSpike (05-15-2018), Dave Neptune (05-15-2018)
  #2   IP: 72.194.220.204
Old 05-16-2018, 01:36 AM
JOHN COOKSON JOHN COOKSON is online now
Afourian MVP
 
Join Date: Nov 2008
Posts: 2,954
Thanks: 33
Thanked 463 Times in 363 Posts
An A4 will also start on two cylinders. Try putting the spark plug wires on the spark plugs in an incorrect firing order then try starting the engine............

TRUE GRIT
Reply With Quote
  #3   IP: 137.200.32.6
Old 05-16-2018, 07:53 AM
joe_db's Avatar
joe_db joe_db is online now
 
Join Date: May 2009
Posts: 3,106
Thanks: 34
Thanked 311 Times in 234 Posts
Well known low power issue. Swap the "right" two plug wires and you get a relatively smooth 50% power engine.
Reply With Quote
  #4   IP: 72.69.36.126
Old 05-16-2018, 10:20 PM
tenders tenders is online now
Afourian MVP
 
Join Date: May 2007
Location: Harlem YC, City Island, NY
Posts: 1,268
Thanks: 24
Thanked 143 Times in 99 Posts
Quote:
Originally Posted by JOHN COOKSON View Post
An A4 will also start on two cylinders. Try putting the spark plug wires on the spark plugs in an incorrect firing order then try starting the engine............

TRUE GRIT
No, don't do that. A backfire in a sailboat engine space is an entirely scary event. DAMHIKT.
Reply With Quote
  #5   IP: 24.18.220.104
Old 05-17-2018, 10:28 AM
sglazebrook sglazebrook is offline
Senior Member
 
Join Date: Mar 2013
Posts: 75
Thanks: 2
Thanked 0 Times in 0 Posts
Accidentally left the #3 & 4 plug wires off and started. It started but I knew immediately what I had done with it running rough and immediately shut it down. Quite amazing actually!
__________________
Scott
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
A4 Runs fine for hours then gets rough jkenan Troubleshooting 52 03-24-2014 09:19 AM
Firing on 2 cylinders and baffled.. Hooper1819 Troubleshooting 12 03-23-2010 07:22 PM
Uh Oh...Water in Cylinders mike7a10 Exhaust System 10 05-19-2009 05:35 AM
water in the cylinders - engine won't start dtelep Troubleshooting 5 06-06-2007 10:18 AM


All times are GMT -4. The time now is 01:46 PM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2018, vBulletin Solutions, Inc.


Universal® is a registered trademark of Westerbeke Corporation

Copyright © 2004-2018 Moyer Marine Inc.

All Rights Reserved