#1
IP: 73.219.74.20
|
|||
|
|||
Broken temperature sensor
The wire leading from the temp gauge broke of at the connection to the brass/bronze sensor bolted into the front of the engine. Is it possible to reattach this, or must the entire wire be replaced back to the gauge? I've considered operating without the gauge, but I know I will be constantly climbing down the stern ladder to test the water by hand.
Or should I replace the entire assembly including the gauge? |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Overheats and don’t know why | pdecker | Troubleshooting | 18 | 11-17-2017 11:53 AM |
Controlling and affecting proper operating temp | ILikeRust | Troubleshooting | 88 | 02-02-2016 01:36 PM |
temperature gauge and alarm sensors on same fitting | capnward | Electrical | 5 | 05-17-2013 10:33 AM |
Misc Stories and Removing that stuck temperature sensor... | marthur | General Maintenance | 5 | 07-22-2012 03:16 PM |
installed alarms now engine temp not right | eric 352 | General Interest | 8 | 01-21-2005 11:33 AM |