#1
IP: 108.246.1.125
|
|||
|
|||
Tartan 34c exhaust make up
I am using my old black pipe exhaust as a template. My question: as this is a screw together assembly I’m sure I’m going to run into one or two joints which when tightened will not align in the most favored position to make the optimum bend to the stack cabinet. Any insights to ensure I get the joint postions correct? Is there a recommended thread dressing to minimize the chance of exhaust leaks? Any suggestions would be appreciated. Thanks
|
The Following User Says Thank You to Tar34 For This Useful Post: | ||
TimBSmith (10-21-2020) |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Tartan S/S standpipe exhaust in C&C Corvette | 67c&ccorv | Exhaust System | 18 | 01-07-2011 02:39 PM |
Tartan 30 Exhaust | jacques debauche | Tartan | 8 | 07-02-2010 03:42 PM |
Tartan 30 exhaust system rebuild | jacques debauche | Tartan | 2 | 05-22-2010 06:48 AM |
Elevated Exhaust Back Pressure | 76oDay | Exhaust System | 9 | 04-19-2010 08:13 AM |
Stuck #4 Exhaust Valve: A special Tartan 30 problem? | jellisfeingold | Tartan | 7 | 12-09-2006 03:11 PM |