Return to the home page...

Go Back   Moyer Marine Atomic 4 Community - Home of the Afourians > Discussion Topics > Electrical

Reply
 
Thread Tools Display Modes
  #1   IP: 24.152.132.140
Old 09-07-2019, 09:32 AM
ndutton's Avatar
ndutton ndutton is offline
Afourian MVP
 
Join Date: May 2009
Location: Torrance, CA
Posts: 8,609
Thanks: 147
Thanked 1,245 Times in 832 Posts
Anecdotal alternator performance

I have a single wire Delco 10Si alternator, 105A (same family as MMI's 120A high output catalog offering) and a battery complement of 4 - Group 31's paralleled into two house banks and 1 - G24 isolated engine starter. My monitoring array includes a digital ammeter that reads alternator output via a Gauss loop sensor on the output wire (as opposed to the more common inline shunt).

Leaving Catalina following an overnighter with refrigeration, water pressure pump and lighting loads running off of the combined house banks I started the engine on the engine starter, dropped the mooring and headed for home. After about a half hour with only the engine starter battery switched to the alternator I switched over to the combined house banks and off of the engine starter. Engine RPM was roughly 1800 when I switched, noticeably lower with the charging load applied.

Upon switching to the partially depleted house banks, the initial alternator output was 75A but pretty quickly dropped to 60A and held there slowly reducing as the battery state of charge came up.

Not too shabby for an alternator mounted on an A4. The belt tension applied by the tensioner was spot on with no squeal (standard single 3/8" V belt). It had never been tested to that level of alternator load.
__________________
Neil
1977 Catalina 30
San Pedro, California
prior boats 1987 Westsail 32, 1970 Catalina 22
Had my hands in a few others

Last edited by ndutton; 09-07-2019 at 10:48 AM.
Reply With Quote
The Following User Says Thank You to ndutton For This Useful Post:
Administrator (09-07-2019)
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 01:30 AM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2019, vBulletin Solutions, Inc.


Universal® is a registered trademark of Westerbeke Corporation

Copyright © 2004-2019 Moyer Marine Inc.

All Rights Reserved