#1
IP: 98.202.55.247
|
|||
|
|||
blower hose connections
I'm a new owner of a 1973 Ericson 27. This is my first sailboat and it's a real project. The previous owners left it in poor repair. One of my projects is to remount the engine compartment blower which was broken off its mounting and left dangling from it's wires when a rebuilt A4 was installed. I'm puzzled over how the hoses are supposed to attach. I am attaching a drawing showing the location of each hose. Hose "A" is still attached between the engine compartment and the exhaust cowl vent, so there is no question there. I'm puzzled over the two remaining hoses. Hose "B" and "C" are laying on the bottom under the fuel tank. "B" attaches to a hole low in the engine compartment on the port side. I assume it connects through the hole in the upper aft side of the compartment to the intake of the blower. Where then does hose "C" connect to? Its connected at one end to the intake cowl vent, but I do not see an opening in the engine compartment for it. Any suggestions?
Michael Downie 1973 E27 #359 Great Salt Lake, Utah |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Blower ducting | luvmyi36 | Safety | 0 | 07-31-2007 07:09 PM |
Where does the blower get attached on a Pearson 30? | uniexpany | Electrical | 2 | 07-12-2006 05:55 PM |
Where does the blower get attached on a Pearson 30? | uniexpany | Pearson | 2 | 07-12-2006 05:55 PM |
blower exhaust | whynot | General Interest | 3 | 05-30-2006 08:33 AM |
Rubber Hose Extending from oil tap below valve chamber cover | 1973 Ericson | General Interest | 1 | 11-17-2005 02:32 PM |