#1
IP: 70.17.238.143
|
|||
|
|||
Columbia 31 new install of A-4
If anybody has any pictures of an A-4 in a Columbia 31, I need to make up the engine bed.....I worked on one a few years ago and if I recall it was "hard mounted" without engine mounts......
Thanks |
#2
IP: 71.232.145.132
|
|||
|
|||
I have a 1970 Tartan 34C. The engine is hard mounted to two longitudinal
molded fiberglass rails by studs that are screwed into holes drilled into the glass. The studs are capped by washers and nuts with small shims underneath as required. I bought some replacement studs like this from McMaster Carr. They can help you select them. for the ones replaced, I poured some west system epoxy strengthened with micofibers into the holes prior to threading the studs in. Hope this helps Art |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Fresh Water Cooling Install | Kurt | Cooling System | 31 | 09-27-2021 07:23 PM |
south pacific columbia 30´ | Blue Knight | Columbia | 13 | 03-15-2010 09:47 PM |
Columbia 31 new install of A-4 | Sid Smith, SR. | General Interest | 1 | 02-26-2010 02:11 PM |
Ranger 29 Windlass Install | charles@pricefarrington.c | General Interest | 0 | 03-16-2009 01:43 AM |
Install new cylinder head | prwiliams1 | General Maintenance | 3 | 08-09-2008 04:29 PM |