I am trying to assemble back all the parts back, after the block undergone a major overhaul. When I was disassembling the engine I put most of the bolts back in their holes so I would know where they go. Well, unfortunately the machine shop that was baking and blasting all the parts removed all the bolts and misplaced them So now I have to find a lot of bolts. MM manual says what bolt width to use most of the time but not length and not thread size.
For example, What bolts do I use to put on the starter? thread seems to be 3/8 but the neck is much thicker..
What length of the 3/8 bolts do I use to put on the flywheel housing?
The flywheel cover seem to be using 1/4-20 bolts but 3/4 is too long and 1/2 i am afraid will be too short.
Is there a nomenclature of all the fasteners used on A4?
As always, Thank you for your time.
Val
For example, What bolts do I use to put on the starter? thread seems to be 3/8 but the neck is much thicker..
What length of the 3/8 bolts do I use to put on the flywheel housing?
The flywheel cover seem to be using 1/4-20 bolts but 3/4 is too long and 1/2 i am afraid will be too short.
Is there a nomenclature of all the fasteners used on A4?
As always, Thank you for your time.
Val
Comment