Return to the home page...

Go Back   Moyer Marine Atomic 4 Community - Home of the Afourians > Discussion Topics > Troubleshooting

Reply
 
Thread Tools Display Modes
  #1   IP: 174.205.19.75
Old 08-30-2018, 09:57 PM
tombrcc tombrcc is offline
Frequent Contributor
 
Join Date: Jul 2016
Posts: 7
Thanks: 0
Thanked 1 Time in 1 Post
repair water exhaust entry

While removing black iron exhaust elbow from the water inlet I developed a crack where in the inlet joins the larger tube. Is there any way to fill this long enough to make it through the next couple months. Moyer is sold out. Can I fill this with plumbing torch and some solder?
Attached Images
 
Reply With Quote
  #2   IP: 192.186.122.174
Old 08-31-2018, 10:15 AM
GregH's Avatar
GregH GregH is offline
Senior Member
 
Join Date: Jun 2015
Location: Kingston, ON
Posts: 298
Thanks: 153
Thanked 22 Times in 20 Posts
Wouldn't that be a good candidate for a little brazing?
Reply With Quote
  #3   IP: 99.30.185.198
Old 08-31-2018, 11:19 AM
thatch thatch is online now
Afourian MVP
 
Join Date: Dec 2009
Location: Santa clarita, Ca.
Posts: 999
Thanks: 59
Thanked 139 Times in 85 Posts
Any competent welder can clean up the area, straighten the water inlet tube and build up (braze) it back to good shape. After the brazing is completed, it would be a good idea to run a drill bit through the tube to make sure that the brazing had not reduced it's internal size.
Tom
Reply With Quote
The Following User Says Thank You to thatch For This Useful Post:
Dave Neptune (08-31-2018)
  #4   IP: 172.95.97.58
Old 08-31-2018, 01:56 PM
Dave Neptune Dave Neptune is online now
Afourian MVP
 
Join Date: Jan 2007
Location: Lake Arrowhead Ca.
Posts: 3,862
Thanks: 365
Thanked 289 Times in 208 Posts
I have "brazed" far worse looking things. Really not a biggie.

If the "brazing" material builds up in the injection tube it can easily be drilled out.

Dave Neptune
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Water bubbling out around spark plugs-need help BobA Troubleshooting 21 10-21-2009 11:54 PM
re-plumbing for hot water heater operation Jesse Delanoy Cooling System 10 04-21-2008 09:05 PM
Water in oil/ steam in exhaust anglosax Troubleshooting 1 09-25-2007 09:49 AM
Water in the Exhaust? kjell72 Exhaust System 1 07-10-2007 08:13 AM
Engine temperature down Unregistered Cooling System 1 11-14-2005 10:22 AM


All times are GMT -4. The time now is 12:57 PM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2018, vBulletin Solutions, Inc.


Universal® is a registered trademark of Westerbeke Corporation

Copyright © 2004-2018 Moyer Marine Inc.

All Rights Reserved