|
#1
IP: 216.123.165.14
10-01-2019, 01:45 PM
|
|||
|
|||
|
How to remove Flame Arrestor
My carburator has just recently been rebuilt and the engine now struggles to start cold, though once started it runs smoothly. I'm thinking either the fuel mixture is set too lean or the choke does not fully open the carb valve when pulled full out. I can easily set the fuel mix but to check the carb valve with choke on/off I need to remove the complete flame arrestor unit entirely, and there begs the question - how do you do that?
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Can a Faulty Flame Arrestor Screen Lead to Throttle Issue? | chanlmee | Troubleshooting | 14 | 03-11-2016 01:47 PM |
| Flame arrestor knurled retaining screw - late model | Don Moyer | Announcements | 11 | 01-07-2015 06:18 PM |
| Cleaning a flame arrestor. | CaptainHatty | Fuel System | 8 | 11-21-2013 11:34 PM |
| Replaced carb - engine won't start (oil in flame arrestor) | bgilbert | Troubleshooting | 18 | 08-23-2011 07:45 AM |
| Coast Guard Approved Flame Arrestor | Shriveguy | Fuel System | 13 | 11-12-2008 10:08 AM |
Threaded Mode