Return to the home page...

Go Back   Moyer Marine Atomic 4 Community - Home of the Afourians > Discussion Topics > Ignition System

Reply
 
Thread Tools Display Modes
  #26   IP: 67.169.215.221
Old 05-14-2020, 01:28 AM
ronstory's Avatar
ronstory ronstory is offline
Senior Member
 
Join Date: Feb 2016
Posts: 216
Thanks: 36
Thanked 64 Times in 50 Posts
Ted--

I would be good to follow Dave N's advice above and if the valves are to tight, they will never fully seat and you will get low/no compression.

The trick is remove the side plate and watch the valves on each cylinder. When both the intake and exhaust valves are in the closed position (valve stems are most visible), you are on the compression stroke. This is also when the cam is on the bottom of the lobe, and you will have the maximum gap between the lifter and the valve stem.

Just check the gap and cold the intake should be 0.010" and the exhaust should be 0.012". Then rotate the crank shaft by half a revolution and look for the next cylinder with both valves closed... and do the same adjustment.

As a bit of foreshadowing... the cylinders will follow 1-2-4-3 in the order.

Good luck!
__________________
Thanks,
Ron
Portland, OR
Reply With Quote
  #27   IP: 155.186.124.219
Old 05-14-2020, 10:02 AM
Dave Neptune Dave Neptune is online now
Afourian MVP
 
Join Date: Jan 2007
Location: Lake Arrowhead Ca.
Posts: 4,185
Thanks: 469
Thanked 463 Times in 318 Posts
Exclamation Indicator balloon use

Ted, when the balloon "starts" to expand you are on the compression stroke. As soon as the balloon starts to expand stop turning. Now look to the flywheel so you can see the "pin" in the center. When this pin ti "vertical" you are ready to check the adjustment. Rotate the engine another 90* and you are ready for the next cylinders valves. Repeat this for all 4 cylinders and you have turned the engine 2 full revolutions.

If you error on adjusting error to the loose side of the adjustment not tight.

If the balloon does not inflate we will need to look to the valves for TDC so they can be adjusted.

Dave Neptune

Last edited by Dave Neptune; 05-14-2020 at 10:09 AM.
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Finding TDC (top dead center) jpian0923 Drawings and Schematics 4 09-18-2016 06:25 PM
Easy distributor question positron Ignition System 15 03-15-2012 05:29 PM
Finding the waterline while inside the boat ILikeRust Exhaust System 15 09-14-2011 01:30 PM
If torqueing was easy , Laker General Interest 14 01-27-2011 02:51 PM
Finding TDC: how critical to be precise? rigspelt Overhaul 4 12-15-2008 05:04 AM


All times are GMT -4. The time now is 06:57 PM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2020, vBulletin Solutions, Inc.


Universal® is a registered trademark of Westerbeke Corporation

Copyright © 2004-2020 Moyer Marine Inc.

All Rights Reserved