Return to the home page...

Go Back   Moyer Marine Atomic 4 Community - Home of the Afourians > Discussion Topics > Aftermarket Kits and Accessories

Reply
 
Thread Tools Display Modes
  #51   IP: 172.56.5.227
Old 04-10-2014, 08:35 PM
liveaboardL liveaboardL is offline
Senior Member
 
Join Date: Mar 2014
Posts: 15
Thanks: 0
Thanked 0 Times in 0 Posts
Can you make your own cap vent?

My cabin stinks very bad for many hours after running the engine & I could not locate the source, but I'd like to try rigging the vented oil cap to direct the fumes outside. Anyone see any problem with just putting a ziplock bag over the vented oil cap & duct-taping a seal and poking a hole in it & running some hose out the cabin hatch while under way? It aught to get the job done, right? How hot does that oil cap get?
Reply With Quote
  #52   IP: 100.40.71.133
Old 04-10-2014, 09:27 PM
scottr scottr is offline
Frequent Contributor
 
Join Date: Sep 2013
Location: Wickford, RI
Posts: 9
Thanks: 0
Thanked 0 Times in 0 Posts
My solution

Check out post 144 here:
http://www.moyermarine.com/forums/sh...t=slash&page=6

(Assuming the link works.)

In case the link doesn't work, the idea is to remove the slash tube that goes to the flame arrester and replace it with heater hose and slide the other end into the blower intake hose. The fumes are then exhausted by the blower. It worked great for me, the cabin smell is gone.
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 09:50 AM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2020, vBulletin Solutions, Inc.


Universal® is a registered trademark of Westerbeke Corporation

Copyright © 2004-2020 Moyer Marine Inc.

All Rights Reserved