Return to the home page...

Go Back   Moyer Marine Atomic 4 Community - Home of the Afourians > Discussion Topics > General Interest

Reply
 
Thread Tools Display Modes
  #1   IP: 75.10.236.3
Old 08-14-2020, 05:45 PM
Sailor Dog Sailor Dog is offline
Member
 
Join Date: Jun 2020
Posts: 2
Thanks: 1
Thanked 0 Times in 0 Posts
Engine Checkout

Hello Afourians,

I'm reaching out for commentary on my pursuit of a replacement engine for our Catalina 27 Atomic 4.

I am considering purchasing a rebuilt engine. This engine was completely rebuilt in 2004 and documented. Soon thereafter as the engine was sitting in the main cabin, the boat was flooded with rain water. The boat was pumped out and the engine was pulled from the boat, flushed with several oil changes, ran briefly and put into dry storage. Two weeks ago I put a small amount of ATF in each cylinder to seep in and lubricate the rings. The engine oil is clean and at the right level. Here's my plan to check out the engine.
With the plugs out I'll turn the engine a few rotations with the starter.
I'll check the compression and then the ignition.
I'll put the plugs back in, connect the spark plugs, connect the fuel supply and cooling water and exhaust.
I'll prime the carburetor, start the engine, run it for minute or two and check the flow of the cooling water.
If all goes well I'll make the deal.

Please share your thoughts.

Fair winds,

Sailor Dog
Reply With Quote
  #2   IP: 24.53.89.131
Old 08-14-2020, 05:56 PM
Peter's Avatar
Peter Peter is offline
Afourian MVP
 
Join Date: Jul 2016
Location: Nova Scotia, Canada
Posts: 297
Thanks: 162
Thanked 140 Times in 101 Posts
Dog,

I would check the oil after running it to make sure it is not milky.

Also pressure test the block and manifold - lots of descriptions on this form on how to do that.

Hope that helps,

Peter
Reply With Quote
  #3   IP: 172.58.75.10
Old 08-15-2020, 10:54 AM
roadnsky's Avatar
roadnsky roadnsky is offline
Afourian MVP
 
Join Date: Dec 2008
Location: Lake Mead, NV
Posts: 3,104
Thanks: 24
Thanked 467 Times in 309 Posts
You may get a few good pointers from this FAQ post #5
__________________
-Jerry

'Lone Ranger'

1978 RANGER 30
Reply With Quote
  #4   IP: 32.211.28.40
Old 08-19-2020, 05:39 PM
Al Schober's Avatar
Al Schober Al Schober is offline
Afourian MVP
 
Join Date: Jul 2009
Location: Uncasville, CT
Posts: 2,002
Thanks: 16
Thanked 578 Times in 405 Posts
If the water was deep enough to submerge the starter, you may have issues there. Sea water will dissolve the springs in the brush rigging. Commutator may need cleaning.
Reply With Quote
  #5   IP: 67.176.201.26
Old 08-19-2020, 08:09 PM
Sam Sam is offline
Afourian MVP
 
Join Date: Apr 2010
Posts: 322
Thanks: 490
Thanked 140 Times in 109 Posts
Picking up on Al's point. About 12 yrs ago my boat sank almost to the deck level [a story for another time] putting the entire engine underwater for most of the weekend. The Lake Michigan water had displaced the oil out of the engine and it was floating on top of the water in the cabin. We gas pumped the water out and refloated and temp patched the boat. We immediately[time is not your friend] went to work on the engine pumping out multiple gallons of water from the block. Cleaned the carb, reassembled and lubed the distributor and was able to start the A4. The alternator was dead and needed rebuilding and we ran off the batteries. Changed the oil w/MMO 4 times and then again later in the season. The starter and the battery selector switch both dramatically failed after that winter layup. Update: still running well today.
Bottom line: I would be leery buying a "flooded" engine unless the issues were immediately addressed.
Reply With Quote
  #6   IP: 137.103.82.227
Old 08-20-2020, 09:27 AM
joe_db's Avatar
joe_db joe_db is online now
Afourian MVP
 
Join Date: May 2009
Posts: 4,474
Thanks: 49
Thanked 1,026 Times in 721 Posts
A friend's Pearson 30 was sunk by a lighting hit in February (we can have thunderstorms any month here).
A couple days later divers raised the boat and they had the A4 running within the hour. Oil leaked out of the interior nooks and crannies for years afterwards, but the engine was fine.
Boats that sink with shore power on or the batteries on have a hard time
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
no water flow, engine overheats shawnb Troubleshooting 10 03-30-2017 01:15 AM
Water in crankcase - bilge flooded part way up engine cvile1617 Troubleshooting 18 04-13-2015 08:52 PM
Engine Sputters and Coughs, and Needed Choke to Run Smooth CaptainChas Troubleshooting 9 06-30-2009 10:50 PM
Engine Dies after approx one hour Trysail Troubleshooting 4 08-07-2008 11:15 AM


All times are GMT -4. The time now is 12:43 PM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.


Universal® is a registered trademark of Westerbeke Corporation

Copyright © 2004-2024 Moyer Marine Inc.

All Rights Reserved