#1
IP: 104.13.213.227
|
|||
|
|||
Mounting lag bolts?
I am soon to mount my replacement A4 in my Tartan 34C (rigid mount) and I need to replace 2 of the lag bolts the stick up from the engine bed. They are bronze with about an 1 and 1/8 machine thread and 2 inches of wood screw thread. 1 inch unthreaded area between the 2 different threads. 3/8 diameter. 4 inch overall length. Does anyone know of a supplier for these? Any help is appreciated. Grant.
|
#2
IP: 108.12.235.197
|
|||
|
|||
Hanger bolts
When I built a new engine bed on our Tartan 34C, I was unable to find an exact match to the lag bolts I removed. The bolts that were the closest match were:
Hamilton Marine Hanger bolt BRZ .38 x 4.00. Mfg #112477 Jamestown Distributors Hanger bolt Sil Bronze 3/8 x 5 # FSBHB38x5 My recollection is that the unthreaded sections were less than 1". I hope this is of some help. Best regards, Jack |
#3
IP: 99.203.55.105
|
|||
|
|||
Don’t know if they may have what you are looking for but they have a lot
Bolt depot.com |
#4
IP: 104.13.213.227
|
|||
|
|||
Jack, Thank You. I will get in touch with them Tuesday. Azazzera, I will take a look there. Thanks also. My engine beds seem good and solid, but whoever removed the old engine bent the studs, so I want to replace them. ____Grant.
|
#5
IP: 108.45.44.91
|
||||
|
||||
McMaster-Carr has them in stainless:
https://www.mcmaster.com/#90915A640
__________________
@(^.^)@ Ed 1977 Pearson P-323 "Dolce Vita" with rebuilt Atomic-4 Last edited by edwardc; 09-01-2018 at 03:50 PM. Reason: Corrected link |
#6
IP: 71.215.61.53
|
||||
|
||||
You may want to stick a piece of dowel in the hole for the lag. It will help it not to strip. All mine stripped on my T34.
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Nuts and bolts | Val V | Overhaul | 6 | 04-22-2014 09:57 PM |
sister bolts | domenic | Boat Construction/Repair | 2 | 08-18-2013 05:13 PM |
water seapage around head bolts | Mike Wythe | Cooling System | 6 | 07-29-2013 08:02 PM |
fuel pump mounting tip | gary g | General Maintenance | 0 | 07-20-2012 02:27 PM |
reseal Manifold mounting bolts | hinters | General Maintenance | 4 | 11-23-2009 05:20 PM |