#1
IP: 71.7.227.12
|
||||
|
||||
Carb questions
Good day,
After some engine issues last summer I cleaned the carb out it was pretty gummed up. Last fall after re-installing the carb I couldn't get my engine to start, now re examining the carb more closely with my (MM A4) manual at hand I noticed a brass piece in the idle passage by the flange where the Carb is mounted to the manifold, is this normal? In addition both upper and lower idle ports are clogged. Any suggestions in clearing these small passages? Prior to cleaning the carb In order to start the engine I needed to throttle up, this must have been a result of the blockage in the idle passage? Last edited by Koerk; 06-05-2018 at 04:36 PM. |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
oops ,, idle hands cause much trouble | BadaBing | Fuel System | 28 | 01-20-2016 03:40 PM |
need some help carb etc. | nyvoyager | Troubleshooting | 5 | 06-11-2013 06:54 AM |
Carb questions | Junebug | Fuel System | 9 | 09-20-2012 02:49 PM |
Carb For Palmer P60 - Same as Atomic 4? | bpowdrell | Fuel System | 3 | 08-29-2012 08:58 AM |
Carb Identity | ScottLynds | Fuel System | 2 | 06-16-2005 11:20 AM |