Return to the home page...

Go Back   Moyer Marine Atomic 4 Community - Home of the Afourians > Discussion Topics > Troubleshooting

Reply
 
Thread Tools Display Modes
  #1   IP: 172.249.104.171
Old 07-08-2018, 11:24 AM
CamaroMan CamaroMan is offline
 
Join Date: Oct 2017
Location: San Pedro, CA
Posts: 35
Thanks: 3
Thanked 7 Times in 5 Posts
plugs wet with fuel / add stat / hotter plugs?

(posting for some1 else)

late model - tstat was missing. Recently cleaned alot of crud out of block. Motor runs fine hours on end, but plugs wet with fuel / struggles to start after running.

I blocked off the bypass hose since there was no tstat installed but im thinking the motor is running too cold -

I suggest running a range or 2 hotter plug and/or installing the stat..

otherwise everything runs gr8 - starts instantly and all ignition components new-
Reply With Quote
  #2   IP: 207.118.20.35
Old 07-08-2018, 12:54 PM
capnward's Avatar
capnward capnward is offline
Senior Member
 
Join Date: Aug 2012
Location: Deer Harbor WA
Posts: 152
Thanks: 5
Thanked 29 Times in 24 Posts
Blocking off the bypass directs more water into the block, cooling the engine more. Reinstalling the tstat or going with hotter plugs won't necessarily make it run hotter. I wouldn't worry too much about running cold, just run it long enough to get it warm. Plugs wet with fuel seems to indicate less spark after the ignition components were installed. Perhaps timing needs to be adjusted. I don't know what could cause it to start instantly when cold, but not start when warmed up. Others on this forum will no doubt enlighten us.
Reply With Quote
  #3   IP: 32.211.28.40
Old 07-08-2018, 02:04 PM
Al Schober's Avatar
Al Schober Al Schober is offline
Afourian MVP
 
Join Date: Jul 2009
Location: Uncasville, CT
Posts: 1,327
Thanks: 4
Thanked 142 Times in 125 Posts
Blocking the bypass will only make the engine run cooler. But, IMHO, this isn't your problem.
I'm confused - struggles to start/ starts instantly. More info?
Are you sure the plugs are wet with fuel (not oil or water)?
You may just be running rich (too rich). A cold engine should need choke to start.
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Polishing Filter GregH Fuel System 27 05-05-2018 11:43 PM
Engine runs for a couple minutes, stops hard, no fuel flow pdecker Troubleshooting 30 05-28-2015 01:17 PM
Hotter plugs redux HalcyonS Ignition System 2 01-03-2014 09:15 AM
Fuel Shutdown Issue gdasw Fuel System 17 06-20-2013 08:53 AM
Engine won't start and I'm at my wits-end ChicagoNewport27 Troubleshooting 64 07-23-2011 12:47 AM


All times are GMT -4. The time now is 03:27 PM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2018, vBulletin Solutions, Inc.


Universal® is a registered trademark of Westerbeke Corporation

Copyright © 2004-2018 Moyer Marine Inc.

All Rights Reserved