Throtle and Clutch controls

[gclayton]

I have the old controls down low in the cockpit. They are stuck together, rust i suspect. Any guidance on how to remove would be a big help as there is no obvious screw or nut.

Thanks

[BryanLee]

I do not know what your controls are like, but my shift control is bolted in from the inside of the boat, not the outside. So to remove it, I would need to unbolt it from inside the boat. Perhaps yours are the same?

[Al Schober]

Not knowing what you have, I hesitate to advise. Could you perhaps submit a picture? Is it a two handle, throttle & shift unit? Perhaps an old Marmac unit? If so, I can tell you how it comes apart. You might even get that thing working again!

[gclayton]

Thanks much.
Ill get pics this weekend and post them