Return to the home page...

Go Back   Moyer Marine Atomic 4 Community - Home of the Afourians > Testing Protocols

Reply
 
Thread Tools Display Modes
  #1   IP: 24.152.132.140
Old 06-22-2019, 03:43 PM
ndutton's Avatar
ndutton ndutton is offline
Afourian MVP
 
Join Date: May 2009
Location: Torrance, CA
Posts: 9,619
Thanks: 198
Thanked 2,208 Times in 1,425 Posts
Spark Test

Perhaps the most fundamental test we can perform on a non-running engine determines if the issue is fuel or spark related. Of the two, spark is much easier to test provided you're prepared. A simple test is to remove a plug or coil wire and hold it close to the engine block or head and watch for a spark as the engine is cranked but here are a few other ways that once in place may be even simpler still:

The Test Pen
We have mentioned it on the forum before, a cool test tool available on Amazon, eBay, etc. that does not require anything to be unplugged. Place the tip of the test pen on a spark plug wire and watch for the test light inside the pen barrel while cranking. This is a yes or no test, it does not offer any spark quality information.


The Spare Spark Plug
The purpose of the following is to have a testing means readily available without digging through lockers and spare parts boxes.

For quite some time Tom Thatcher (Thatch on the forum) has kept a spare spark plug laying loose on the engine's alternator/lifting eye bracket for a handy spark test. He found the plug picked up sufficient ground for a test just by sitting there. His test method was to pull a plug wire, put it on the test plug and crank. Recently he decided to make it a little more permanent (elegant?) and improve the grounding so he came up with a magnetic base spare plug mount that can be positioned anywhere on the engine.


As he and I tend to do, we each came up with our own spare plug mount systems and then compared notes afterward. Here is my version. It utilizes the lifting eye hole that we aren't using anyway.


Test Protocol
Remove a plug wire and place it on the spare test plug and crank the engine. Observe for spark (yes or no) and quality (blue = good, yellow = not so good). No spark = ignition problem, yes spark = fuel problem.
__________________
Neil
1977 Catalina 30
San Pedro, California
prior boats 1987 Westsail 32, 1970 Catalina 22
Had my hands in a few others
Reply With Quote
  #2   IP: 99.30.185.198
Old 06-22-2019, 06:27 PM
thatch thatch is online now
Afourian MVP
 
Join Date: Dec 2009
Location: Santa clarita, Ca.
Posts: 1,079
Thanks: 235
Thanked 257 Times in 138 Posts
Thanks Neil, It' obvious that any number of versions of this device can be made. I guess, ironically, that both Neil and I found the nice flat section of the lifting ring/alternator bracket, to be the ideal spot to place this gadget.
Tom
Reply With Quote
  #3   IP: 24.152.132.140
Old 06-22-2019, 06:37 PM
ndutton's Avatar
ndutton ndutton is offline
Afourian MVP
 
Join Date: May 2009
Location: Torrance, CA
Posts: 9,619
Thanks: 198
Thanked 2,208 Times in 1,425 Posts
Quote:
Originally Posted by thatch View Post
I guess, ironically, that both Neil and I found the nice flat section of the lifting ring/alternator bracket, to be the ideal spot to place this gadget
We may be victims of our own boats (Catalina 30's) with zero clearance for anything higher than spark plug #1.
__________________
Neil
1977 Catalina 30
San Pedro, California
prior boats 1987 Westsail 32, 1970 Catalina 22
Had my hands in a few others
Reply With Quote
  #4   IP: 71.38.87.228
Old 06-23-2019, 10:18 AM
roadnsky's Avatar
roadnsky roadnsky is offline
Afourian MVP
 
Join Date: Dec 2008
Location: Lake Mead, NV
Posts: 3,104
Thanks: 24
Thanked 467 Times in 309 Posts
Man... the creative brain power between you two is amazing.

I'll never forget spending an evening with both of you.
I was mentally exhausted just listening to the back-n-forth conversation!
__________________
-Jerry

'Lone Ranger'

1978 RANGER 30
Reply With Quote
  #5   IP: 99.30.185.198
Old 06-23-2019, 10:26 AM
thatch thatch is online now
Afourian MVP
 
Join Date: Dec 2009
Location: Santa clarita, Ca.
Posts: 1,079
Thanks: 235
Thanked 257 Times in 138 Posts
Jerry, I'd love to recreate that evening again sometime.
Tom
Reply With Quote
  #6   IP: 97.93.70.7
Old 06-23-2019, 10:44 AM
Dave Neptune Dave Neptune is online now
Afourian MVP, Professor Emeritus
 
Join Date: Jan 2007
Location: Grove, Oklahoma
Posts: 5,035
Thanks: 711
Thanked 1,289 Times in 839 Posts
Great way to mount. Don't like seeing them on good running well maintained A-4's. I do like seeing them on engines with issues for diagnostics.

I too have used a spark plug for checking spark however it can be difficult to see the "jump of the spark". I recommend removing the ground lug from the spark plug. First this gives a larger gap to jump and it is far easier to see!!l You will also be able to "audibly" hear the "snap" as well as see the spark. The bluer the better. A spark with a yellowish flash is not good.

FYI, the hi-voltage ignition (the spark) needs to jump across a gap which is no big deal but when you add compression to the "chamber" this compression also offers up a great deal of resistance which is why you need a blue snappy spark!

Dave Neptune
Reply With Quote
The Following 4 Users Say Thank You to Dave Neptune For This Useful Post:
AFisch (09-27-2019), Marty Levenson (06-23-2019), Sam (06-23-2019), thatch (06-23-2019)
  #7   IP: 24.152.132.140
Old 06-23-2019, 11:23 AM
ndutton's Avatar
ndutton ndutton is offline
Afourian MVP
 
Join Date: May 2009
Location: Torrance, CA
Posts: 9,619
Thanks: 198
Thanked 2,208 Times in 1,425 Posts
Good info on removing the ground ear Dave. About having a spare plug on a good running engine, it's the same as having a fuel pressure gauge. It rides along harmlessly until it's needed and then you're glad you have it.
__________________
Neil
1977 Catalina 30
San Pedro, California
prior boats 1987 Westsail 32, 1970 Catalina 22
Had my hands in a few others
Reply With Quote
  #8   IP: 192.186.122.174
Old 09-27-2019, 08:53 AM
GregH's Avatar
GregH GregH is offline
Afourian MVP
 
Join Date: Jun 2015
Location: Kingston, ON
Posts: 564
Thanks: 385
Thanked 103 Times in 80 Posts
Tried looking online but maybe not seeing it it.. what is the ground lug/ear and how does one remove it?
__________________
Greg
1975 Alberg 30
Reply With Quote
  #9   IP: 24.152.132.140
Old 09-27-2019, 08:58 AM
ndutton's Avatar
ndutton ndutton is offline
Afourian MVP
 
Join Date: May 2009
Location: Torrance, CA
Posts: 9,619
Thanks: 198
Thanked 2,208 Times in 1,425 Posts
Dave was referring to the little curved piece on the bottom of the spark plug. Wire cutters or a small grinder will do the trick.
__________________
Neil
1977 Catalina 30
San Pedro, California
prior boats 1987 Westsail 32, 1970 Catalina 22
Had my hands in a few others
Reply With Quote
The Following User Says Thank You to ndutton For This Useful Post:
GregH (10-02-2019)
  #10   IP: 107.77.97.125
Old 09-27-2019, 05:18 PM
lat 64's Avatar
lat 64 lat 64 is offline
Afourian MVP
 
Join Date: Oct 2008
Location: Fairbanks, Alaska
Posts: 1,964
Thanks: 39
Thanked 240 Times in 157 Posts
Thumbs up

I made one for my lawn mower. just a bent wire permanently fix on the cyl. head.
Every engine should have one!
__________________
Whiskeyjack a '68 Columbia 36 rebuilt A-4 with 2:1

"Since when is napping doing nothing?"
Reply With Quote
  #11   IP: 70.186.108.69
Old 10-02-2019, 01:13 AM
CajunSpike's Avatar
CajunSpike CajunSpike is offline
Senior Member
 
Join Date: Jan 2018
Location: New Orleans, LA
Posts: 240
Thanks: 222
Thanked 41 Times in 31 Posts
Ditto on the spark color. Trying to get the motor running when I first got the boat. Checked the spark and saw a yellow spark. Though it may be enough but my experiences with beetle motors told me it should be blue. Eventually determined points were badly adjusted too open, so was not enough time to build up power before spark...resulting in low voltage yellow spark. This was the final key to getting the motor started and running.
__________________
Bill L.
1972 Ericson 27
Hull #61
Atomic 4
Reply With Quote
The Following User Says Thank You to CajunSpike For This Useful Post:
Administrator (10-02-2019)
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
No spark... sailhog Ignition System 17 05-11-2019 10:04 PM
Coil troubleshooting with a test light? JonnyQuest Ignition System 2 05-04-2013 09:33 AM
White smokes+gasoline+black spark plugs Tiree Troubleshooting 25 08-23-2010 12:33 PM
Anemic Spark bbryan Ignition System 2 11-10-2008 11:44 AM
Spark / No Spark jayw Ignition System 2 06-13-2007 02:12 PM


All times are GMT -4. The time now is 07:50 PM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.


Universal® is a registered trademark of Westerbeke Corporation

Copyright © 2004-2024 Moyer Marine Inc.

All Rights Reserved