|
View Poll Results: What is the steady state temperature of your engine? | |||
120 degrees or below | 20 | 9.22% | |
130 degrees | 12 | 5.53% | |
140 degrees | 39 | 17.97% | |
150 degrees | 17 | 7.83% | |
160 degrees | 59 | 27.19% | |
170 degrees | 29 | 13.36% | |
180 degrees or higher | 41 | 18.89% | |
Voters: 217. You may not vote on this poll |
|
Thread Tools | Display Modes |
#10
IP: 173.48.103.104
|
||||
|
||||
I see the cast street plumber's fitting at the back of the manifold. I recommend you do likewise at the thermostat intake and the fitting at the front of the manifold. Reversing the hoses on the manifold (The Thatch Modification) would complete the upgrade.
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Temperature Gauge question | Unregistered | Cooling System | 5 | 12-28-2010 11:46 AM |
Temperature gauge | Mark S | Troubleshooting | 5 | 05-21-2009 11:09 AM |
Temperature Gauge Sending Unit | Jesse Delanoy | Cooling System | 6 | 10-25-2008 07:41 AM |
Erratic temperature gauge | HerbertFriedman | Cooling System | 3 | 10-14-2007 06:43 PM |
Temperature gauge problems? | omec | Cooling System | 0 | 07-16-2007 12:37 PM |