Return to the home page...

Go Back   Moyer Marine Atomic 4 Community - Home of the Afourians > Discussion Topics > Cooling System

Reply
 
Thread Tools Display Modes
  #1   IP: 71.101.217.55
Old 04-14-2006, 10:17 AM
Unregistered
Guest
 
Posts: n/a
water pump = water in oil

I had water in my oil , and after many hours of testing , realized that when I replaced the crank and bearings , I had also rebuilt the water pump and installed the seal on the water chamber side backwards . Water was squirting across the weep hole and striking the oil seal . From there it ran down onto the shaft and thru the oil seal and into the oil pan . so , make sure the seals go in facing the correct way !
Reply With Quote
Reply

Tags
None

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Moderation Tools:
Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Leaking Water Pump Seals Unregistered Cooling System 4 11-02-2008 12:52 PM
Emergency Bilge Pump (T in water intake) sailorken General Interest 0 11-05-2005 08:40 AM
water pump priming meander Cooling System 1 06-06-2005 02:48 PM
Replacing water pump Bryan Howell Cooling System 7 11-27-2004 11:46 AM
Water pump impeller questions Mr. K Cooling System 1 11-16-2004 09:36 AM


All times are GMT -4. The time now is 05:25 AM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.


Universal® is a registered trademark of Westerbeke Corporation

Copyright © 2004-2024 Moyer Marine Inc.

All Rights Reserved