|
#1
IP: 72.91.48.64
11-21-2015, 01:55 PM
|
||||
|
||||
|
head removal oh boy!
Is it at all possible to remove the head WITHOUT removing the studs? I have been at the Blaster,TAP, Tap, TAP, Blaster, Tap, Tap,etc. thing for 2 days now and wonder if it has ever been done? I intend to begin the process of utilizing the New stud remover I now own. However it looks to me that it will gouge into the threads of the studs as it is tighten into them. Is there a special stud remover that is designed specifically for 3/8in fine thread studs? Tomorrow is the big day, care to weigh-in on how many break? The engine was rebuilt at Moyer in 2008.
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Head Removal Due to Power Loss | Bruce A | Troubleshooting | 58 | 07-18-2012 11:10 AM |
| Head Removal | PT26 | Grampian | 33 | 04-09-2012 06:10 AM |
| Head Removal Tool | Hughes35 | Overhaul | 24 | 04-19-2011 04:44 PM |
| A4 Cylinder Head Removal | doralda | General Maintenance | 0 | 05-06-2007 12:26 AM |
| Removal of the cylinder head studs | Unregistered | General Maintenance | 1 | 12-18-2005 12:34 PM |
Threaded Mode