Return to the home page...

Go Back   Moyer Marine Atomic 4 Community - Home of the Afourians > Discussion Topics > General Interest

Reply
 
Thread Tools Display Modes
  #1   IP: 99.203.64.145
Old 12-18-2019, 07:39 AM
sagem57's Avatar
sagem57 sagem57 is offline
Frequent Contributor
 
Join Date: Nov 2019
Posts: 8
Thanks: 4
Thanked 0 Times in 0 Posts
Accessory drive

Finally got around to finishing the oil level modification to my accessory drive and am putting a new seal in the pulley end of the unit. It's been awhile since I removed that seal and I'm not sure how deep into the casting to set it. It is flush to the casting now but it looks like it's going to be quite a challenge to get the key into the slot for the pully, hence the question. Should it be set deeper and how much?
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Accessory Drive bearing replacement sastanley General Interest 15 03-31-2017 08:45 PM
accessory drive nyiftos General Interest 5 03-19-2014 08:00 AM
Accessory Drive Failure? Ajax General Maintenance 20 02-07-2013 07:49 AM
Rebuild Accessory Drive ghaegele Overhaul 2 05-18-2009 11:24 AM
Flywheel and Accessory drive R & R Ken General Interest 3 11-24-2007 11:34 AM


All times are GMT -4. The time now is 04:31 AM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2024, vBulletin Solutions, Inc.


Universal® is a registered trademark of Westerbeke Corporation

Copyright © 2004-2024 Moyer Marine Inc.

All Rights Reserved