Return to the home page...

Go Back   Moyer Marine Atomic 4 Community - Home of the Afourians > Discussion Topics > Reversing Gear

Reply
 
Thread Tools Display Modes
  #1   IP: 107.77.106.47
Old 09-18-2019, 12:10 PM
caretta caretta is offline
Member
 
Join Date: Oct 2015
Posts: 4
Thanks: 0
Thanked 0 Times in 0 Posts
Another lost forward retaining pin

Hi,

Iím rarely post but I need to stop and think a minute before proceeding. This has been covered before but here goes. Lost my ability to get into either forward or reverse and discovered the forward retaining pin had backed out and is now in the sump somewhere. Iíve spent sometime trying to retrieve it and during the process the end came of my flexible magnet.

So now I have 2 pieces of metal in the sump.

I have a replacement retaining pin coming but need to motor up to about 90 Minutes to where I will have the boat pulled and stored in a week so I donít have time to remove the reversing gear to get in deeper.

Am I crazy to go for it and motor with the stuff in the oil pan to get the boat on the hard?

Thank for any opinion

Chris
Reply With Quote
  #2   IP: 99.30.185.198
Old 09-18-2019, 12:32 PM
thatch thatch is offline
Afourian MVP
 
Join Date: Dec 2009
Location: Santa clarita, Ca.
Posts: 1,038
Thanks: 120
Thanked 161 Times in 101 Posts
Hi, There is certainly enough room under the clutch pack that those pieces should not pose a problem. The rotating parts in that area are well above the bottom of the pan. I have a feeling that the adjusting screw, along with the lock washer and the magnet will "nestle" together comfortably. Actually, I have a magnetic rod, that is part of the oil pump-out plug, that picks up a considerable amount of "magnetic sludge" between oil changes. If it were my engine, I'd simply replace the adjustment locking screw, along with a new lock washer and consider it fixed,
Tom
Reply With Quote
The Following User Says Thank You to thatch For This Useful Post:
Dave Neptune (09-18-2019)
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
reverse gear adjustments gilbert landin Reversing Gear 12 10-17-2013 08:31 PM
Lost forward gear Val V Drive Train / Propellers 8 10-09-2013 04:04 PM
Forward and Reverse Gear Adjustment Issues CraigRun Reversing Gear 12 05-17-2012 09:15 PM
Pressure on the drive lever to fully engage? Andy Mck Reversing Gear 6 10-08-2009 10:33 AM
Retaining pin lost!! capnjack Reversing Gear 1 08-07-2007 12:14 AM


All times are GMT -4. The time now is 11:54 PM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2019, vBulletin Solutions, Inc.


Universalģ is a registered trademark of Westerbeke Corporation

Copyright © 2004-2019 Moyer Marine Inc.

All Rights Reserved