View Single Post
  #23   IP: 99.7.118.97
Old 05-04-2018, 12:13 PM
bcbristoll bcbristoll is offline
Senior Member
 
Join Date: Apr 2018
Location: St. Francis, Wis.
Posts: 18
Thanks: 0
Thanked 0 Times in 0 Posts
Hi again,
Oil change and plug replacement went fine. Also connected the batteries.

Question 1 (photo 1) There are 2 additional wires connecting the pos and negs together (connected in parallel). I thought one battery was for electronics and one for the motor. Doesn't hooking them together kind of negate this idea ?? Is this a good idea ??

2. 2 valves here. I assume one is for the fuel, what's the red handled one?
3. The engine compartment is filthy....I'd like to steam clean this but is there a better solution?

4. Here are 2 valves connected together any ideas ? (photo 3)

5. And of course there is this valve way in the back of the engine.(photo 4)

6. And finally, what is this ? (photo 5)

All right now I'm sure you want a consultants fee...

Didn't get a chance to pull of the distributor cap to take a look underneath...with any luck it'll have electronice points but somehow I don't think so.
Attached Images
     
Reply With Quote