The knot meter on the MC was not functioning properly when I bought her so I disconnected it. On a calm day, using my GPS, I made runs at varying RPMs to set a base RPM/MPH list. I use MPH because the ICW is in statute miles. So I know how fast I should be going and can determine the effect of wind and current. I can usually judge my speed fairly closely by observing the bubbles off the stern. This system does not work well when in a current. It is basically opposite. If the bubbles are ripping by I am probably going slower than expected for the RPMs into a strong current. If they are slow moving I am likely moving faster than expected with the current. Does the knot meter give the same “reversed” readings? If anchored in a 2 knot current does the meter read 2 knots? Dan S/V Marian Claire
|