View Single Post
  #5   IP: 73.132.159.159
Old 02-07-2017, 03:53 AM
Nanook Nanook is offline
Senior Member
 
Join Date: Nov 2016
Location: Temporarily exiled to Annapolis
Posts: 17
Thanks: 0
Thanked 3 Times in 3 Posts
The length of the lever doesn't matter as long as the attachment point remains the same distance from the transmission shifting shaft. They normally have two holes drilled through the lever, if you were and are using the second hole up, remove it from the engine and cut it off just above the holes. Hacksaw works just fine. Smooth the sharp edges with a file and touch up the paint.

If it is easier and still available, just swap the lever over from the old one.
Reply With Quote