View Single Post
  #3   IP: 99.30.185.198
Old 08-31-2018, 10:19 AM
thatch thatch is online now
Afourian MVP
 
Join Date: Dec 2009
Location: Santa clarita, Ca.
Posts: 1,079
Thanks: 235
Thanked 257 Times in 138 Posts
Any competent welder can clean up the area, straighten the water inlet tube and build up (braze) it back to good shape. After the brazing is completed, it would be a good idea to run a drill bit through the tube to make sure that the brazing had not reduced it's internal size.
Tom
Reply With Quote
The Following User Says Thank You to thatch For This Useful Post:
Dave Neptune (08-31-2018)